MacKay Guardian SOLO, Руководство по эксплуатации и обслуживанию

Страница: 59 / 79

MacKay Guardian™ Solo
Operation and Maintenance Guide, v. 1.5
iv)
Pull the coin chute front forward of the zinc frame part. This will fully expose the coin
chute.
v)
To remove the coin slot from the coin chute front, insert the tip of a flat bladed
screwdriver into the coin slot and lift up on the coin slot.
2)
Remove the SmartChute™ coin discriminator (coin chute).
i)
Gently pull the coin chute straight forward and away from the back frame assembly.
You will note that on the back frame assembly there is a male header connector for
connection with a female connecter on the coin discriminator. It may be necessary to
rock the coin discriminator assembly slightly while pulling the coin discriminator away
from the back frame assembly.
3)
Remove the battery holder and battery pack (if not previously done) by removing the two
screws that hold the battery cover in place.
4)
Remove the back plane board by removing the four retaining screws.
ii)
Remove the ribbon cable from the back plane board by pressing on the ejectors of
the mating connector on the back plane board.
9.6 Replacing Coin Discriminator
If a coin discriminator cannot be cleaned out or becomes damaged it will be necessary to replace
the coin discriminator. Use the following procedure to replace the coin discriminator:
1)
Separate the coin chute assembly front from the main meter frame as previously
described in Section 9.5.
2)
Using a Phillips #2 screwdriver, unscrew the long front screw from the face of the Solo
coin chute front zinc part, until it is no longer connected to the rear zinc part. Note that
the screw will not actually fall free as it is retained by a small plastic retaining washer that
prevents the screw from falling away from the zinc frame and becoming lost.
3)
Unscrew the lower two captive screws found at the lower back of the coin chute
assembly. Note that these screws are self-retaining and will remain on the rear zinc
frame when unscrewed from the coin chute front zinc.
4)
Pull the coin chute zinc front forward and clear of the main meter frame. This will fully
expose the coin discriminator.
5)
To remove the coin slot from the coin-card front, insert the tip of a flat bladed screwdriver
into the coin slot and lift up on the coin slot.
6)
Remove the coin discriminator from the plug to which it is attached.
49