Mace HVFlo XCi, Руководство по эксплуатации продукта

Страница: 252 / 255

WARNING: Make sure you understand AND follow the “ Installing FloSeries3
Cards ” procedure BEFORE the next steps:
4. Remove all cards EXCEPT the Controller card (Slot#0) from the FloSeries3 backplane.
WARNING: You MUST note the Slot# that each individual card was
removedfrom, as they MUST be replaced into the same slots.
5. Wait for at least 1 minute, This allows the microprocessor on each card to reset .
6. Re-connect the battery by plugging the white connector back onto “ J1 Battery ”. It will only connect
one way.
7. Replace each of the cards back into the SAME Slot#'s from which they were removed. This should be
done one card at a time with at least a 30 second delay between each card.
8. When all cards have been replaced, re-install the bracket that holds in the cards.
WARNING: Take care not to drop screws or touch any of the cards with the
screwdriver as damage may occur.
9. "Connect" to device with and " Set device date/time
" from the "
System
" menu if required.
10. Click " System
", then "
Card Check
" and ensure that all installed cards are visible. If not, follow the
procedure outlined in "
Installing FloSeries3 Cards
".
11. Re-configure device if required
NOTE: Depending on the state of the device prior to re-initialisation this
may/may not be necessary. If required, "Load setting" from the file you saved
in Step 1 above.
MACE XCi User Manual - 252 -