WINDROWER TRACTOR OPERATION
Form # 169017
60
Issue – June 2008
6.3.6.2.1 Reverse In Cab Forward Mode
WARNING
Back up slowly. Steering is opposite to
normal when reversing. Hold steering wheel
at the bottom and turn wheel in direction you
want the rear (cab-forward) of the machine to
travel.
a. Move speed-range switch (D) to
L
.
b. Move throttle lever (F) to a mid-range position.
NOTE
Reversing in low speed-range and at
reduced engine speed is recommended
since steering will be less sensitive than at
higher speed settings.
CAUTION
Check again to be sure all bystanders have
cleared the area.
c. Move the GSL (A) rearward to desired speed.
d. Steer
as
shown.
6.3.6.3 Engine Forward Operation
a. Swivel operator’s station to engine forward
position as follows:
1. Place ground GSL (A) in N-DETENT and
lock steering wheel. Engine can be running.
IMPORTANT
If GSL is not in N-DETENT, damage to the
GSL cable may result when swivelling
operator’s station.
2. Pull up on knob (B) and hold to release latch
(C) at base of steering column.
3. Turn steering wheel clockwise to pivot
operator’s station counter-clockwise 180°
until pin engages latch to secure operator’s
station in new position.
b. Start engine. Refer to Section 6.3.5.1 Starting.
(continued next page)
CAB FORWARD MODE
ENGINE FORWARD – SEAT FACES ENGINE
DIRECTION OF TRAVEL
C
A
B
D
F
A