OPERATOR’S STATION
Form 169017
41
Issue – June 2008
5.17.5
Cab Display Module (CDM)
Programming
The monitoring system requires programming
for each header and the header must be
attached to the tractor. Programming the
system may be accomplished with or without the
engine running. If the engine is running, the
transmission must be in neutral. If the engine is
not running, the ignition must be on. The
programming mode can be exited at any time by
pressing the PROGRAM switch or by turning off
the ignition. The system only needs to be
programmed once for each header unless the
operator needs to change a particular setting to
suit windrowing conditions or modifications to
the machine. Most functions have been pre-
programmed at the factory but can be changed
by the operator if required.
NOTE
Contact your dealer for information
regarding software updates to the
electronic modules. Your dealer will have
the necessary interface tools and access
to the latest software upgrades.
* Fast Scroll Applies Only When Changing Knife Speed, Overload Pressure, and Tire Size.
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
MENU ITEM SCROLL FORWARD
Displays Value Under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line – Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
SIDE DISPLAY
Displays Software Revision Status
Upper Line – D### (CDM)
Lower Line – C### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing
SELECT
Switch
Press To Exit Program Mode.