Page
1
of
2
Drive Shaft Assembly Replacement
Elemendt
®
1000
Service Bulletin
SVC-016-0019-02
Description
: These instructions describe how to replace the drive shaft assembly onto existing drive plates in the field.
Required tools
Required parts available from Hardt
(P/N)
Wrench set
Ratchet set
Torque wrench
Ruler/Tape measure
3ft level (or equivalent metal straight edge)
1x Drive Shaft Assembly
(99-15367)
1 hr
1.
BEFORE YOU START
ENSURE THE ROTISSERIE IS COOL TO THE TOUCH BEFORE
PERFORMING THIS PROCEDURE.
2.
Remove drive assembly
a. Use the green manual drive advance switch to rotate the
drive until the slot of the drive hub is horizontal.
b. Lift the left side of the drive assembly out of its cradle, then
guide the end key shaft (right side of the drive assembly) out
of the slotted hub as shown.
c.
Carefully guide the drive assembly out of the oven cavity.
Figure 1
3.
Disassemble drive assembly
- Keep all hardware for following steps
Figure 2
a.
b.
c.
