OPERATOR’S STATION
Form # 169017
34
Issue – June 2008
CAB FORWARD/ENGINE RUNNING/HEADER ENGAGED
DRAPER HEADER/INDEX SWITCH OFF
(Scroll Through Display with CDM Switch or GSL Switch)
DISPLAY (Lower or Upper Line)
DESCRIPTION
#####.# ENGINE HRS
Total Engine Operating Time.
#####.# HEADER HRS
Total Header Operating Time.
##.# ACRES/HOUR
##.# HECTARES/HOUR
(If Metric)
Actual Cutting Rate In Acres (Hectares)/Hour.
###.# SUB ACRES
###.# SUB HECTARES
(If Metric)
Area Cut Since Last Reset.
###### TOTAL ACRES
###### TOTAL HECT
(If Metric)
Total Area Cut By Machine.
##.## REEL MPH
##.## REEL KPH
(If Metric)
##.## REEL SENSOR
(If Sensor Disabled)
Reel Peripheral Speed.
##.# DRAPER SPEED
Draper Speed (0.0-10.0).
#### KNIFE SPEED
#### KNIFE SENSOR
(If Sensor Disabled)
Knife Speed In Strokes Per Minute.
##.# HEADER HEIGHT
##.# HEADER SENSOR
(If Sensor Disabled)
Distance Setting (00.0-10.0) Between Cutterbar &
Ground.
##.# HEADER ANGLE
##.# HEADER SENSOR
(If Sensor Disabled)
Angle Setting (00.0-10.0). Header Relative To
Ground.
##.# L FLOAT R ##.#
Left And Right Float Setting (0.0-9.9).
LOAD|
■■■■■■■■■■■■
Bar Graph Representing Hydraulic Operating
Pressure. If sensor disabled, LOAD does not
display. See Note below.
##.# VOLTS
Engine Electrical System Operating Voltage.
SCROLL
(Lower Line)
Displays Sub-Menu After 2-3 Seconds. Press
SELECT to cancel.
NOTE: The load sensor is factory installed on M200 (optional for M150) to monitor knife/conditioner circuit
pressure. To monitor reel circuit pressure, relocate sensor as per Instruction 169031 which is available
through your dealer.
(Scroll Through Sub-Menu Display with CDM Switch)
SCROLL SUB-MENU (Lower Line Only)
#### KNIFE SPEED
##.# HEADER HEIGHT
LOAD|
■■■■■■■■■■■■
##.## REEL MPH
##.# DRAPER SPEED
KNIFE SPD OVERLOAD
(Lower Line)
Knife Speed Drops Below Programmed Set-Point.