MacDon M1240, Руководство оператора

Страница: 146 / 488

OPERATION
8. Press switch (A) for road lights. Always use these lights
when driving machine on roads.
a. Press switch (B) for high/low lights as required
when other vehicles are approaching.
IMPORTANT:
Do NOT use fi eld lights on roads; other drivers
may be confused by them.
9. Press switch (C) to activate beacons.
10. Press switch (D) to activate hazard lights.
Figure 4.45: Light Switches
11. Set the desired maximum ground speed limit. Refer to
Adjusting Ground Speed Limit, page 126 .
NOTE:
Maximum ground speed can be set while the
windrower is moving. Anticipate acceleration or
deceleration if changing maximum speed while
moving.
12. Slowly push throttle (A) to full forward (operating
speed).
CAUTION
Check again to be sure all bystanders have cleared
the area.
13. Move the GSL (B) out of N-DETENT and slowly forward
to desired speed.
Figure 4.46: Operator Console
14. If towing a header, refer to Towing Header with
Windrower, page 138 .
Figure 4.47: Towing a Header
214053
134
Revision A