MacDon M1240, Руководство оператора

Страница: 158 / 488

OPERATION
8. For hydraulic center-link without self-alignment:
Relocate pin (A) in frame linkage as required to
raise the center-link (B) until the hook is above the
attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the
header as the windrower approaches the header
for hookup.
Figure 4.65: Hydraulic Center-Link without
Self-Alignment Kit
9. Drive the windrower slowly forward so the feet (A) on
the windrower enter the supports (B) on the header.
Continue to drive slowly forward until the feet engage
the supports, and the header nudges forward.
Figure 4.66: Header Support
10. For hydraulic center-link with self-alignment:
Adjust position of the center-link cylinder (A) with
switches on the GSL until the hook (B) is above the
header attachment pin.
11. For hydraulic center-link without self-alignment:
Push down on rod end of link cylinder (C) until hook
engages and locks onto header pin.
IMPORTANT:
Hook release (D) must be down to enable self-locking
mechanism. If the release is open (up), manually
push it down after hook engages header pin.
12. For hydraulic center-link with self-alignment:
Lower center-link (A) onto the header with REEL
DOWN switch on the GSL until it locks into position
(hook release [D] is down).
13. For hydraulic center-link with self-alignment:
Check that center-link is locked onto header by
pressing the REEL UP switch on the GSL.
Figure 4.67: Hydraulic Center-Link
214053
146
Revision A