215184
285
Revision A
1008418
A
B
Figure 8.44: Idler Roller
6.
Ensure idler roller (A) is between draper guides (B).
1021001
A
B
C
D
E
Figure 8.45: Left Tension Adjuster Shown
–
Right
Opposite
IMPORTANT:
Do
NOT
adjust nut (C). This nut is used for draper
alignment only.
7.
To loosen draper tension:
•
Turn adjuster bolt (A) counterclockwise. White indicator
bar (B) will move outboard in the direction of arrow (D)
to indicate that the draper is loosening. Loosen until the
white indicator bar is at the halfway point in the
window.
8.
To tighten draper tension:
•
Turn adjuster bolt (A) clockwise. White indicator bar (B)
will move inboard in direction of arrow (E) to indicate
that the draper is tightening. Tighten until the white
indicator bar is at the halfway point in the window.
IMPORTANT:
To avoid premature failure of the draper, draper rollers,
and/or tightener components, do
NOT
operate if the white
bar is not visible.
IMPORTANT:
To prevent scooping dirt, ensure the draper is tight enough
that it does not sag below the point where the cutterbar
contacts the ground.