![background image](http://html.mh-extra.com/html/macdon/d1-series/d1-series_unloading-and-assembly-instructions_685658006.webp)
Section
Summary of Change
Internal Use
Only
•
To avoid bodily injury or death from unexpected start-up or
fall of raised machine, always stop engine, remove key, and
engage safety props before going under machine for any
reason.
3.4 Attaching Reel Height Sensor,
page 133
•
Figure
•
ECN 58283: Added AGCO IDEAL
™
to picture legend.
•
Added arrows to the picture.
ECN 58283
Tech Pubs
3.4 Attaching Reel Height Sensor,
page 133
•
See NOTE below Figure
Added the following to the NOTE:
•
For configuration (A), pointer (D) points to the
FRONT
of the
header.
•
For configuration (B), pointer (D) points to the
REAR
of the
header.
Product Support
5.5 Unloading with a Combine,
page 162
•
Step
Added reference to combine manual.
Tech Pubs
6.1 Installing Filler Cap, page 175
•
Step
•
Step
•
Step
Updated picture to show change to hydraulic tank filler neck.
ECN 57856
6.1 Installing Filler Cap, page 175
Removed step:
• “
Apply hydraulic pipe controlled strength pipe thread sealant
(Loctite
®
565 or equivalent) to screws.
”
ECN 59259
6.1 Installing Filler Cap, page 175
•
Step
•
Step
Updated picture to show change to hydraulic tank filler neck.
ECN 57856
6.2 FM100 Feed Auger
Configurations, page 178
Narrow configuration as the standard configuration:
Added
AGCO IDEAL
™
Series
ECN 59301
6.2 FM100 Feed Auger
Configurations, page 178
Narrow configuration:
Added information about the quantity of
flightings and fingers.
Tech Pubs
6.2 FM100 Feed Auger
Configurations, page 178
Medium configuration as the standard configuration:
Added the
following combines:
•
Case IH 2300/2500 Series
•
Case IH 5/6/7150, 7/8/9250
•
CLAAS 7000/8000
•
John Deere S76/77/78/790
•
New Holland CR 10.80/10.90
•
Rostselmash Torum 760/780
Engineering
Tech Pubs
6.2 FM100 Feed Auger
Configurations, page 178
Medium configuration as the standard configuration:
Tech Pubs
215184
iv
Revision A