215184
377
Revision A
Setting Cutting Height
–
CLAAS 600 and 700 Series
WARNING
Check to be sure all bystanders have cleared the area.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1003735
A
Figure 9.162: CLAAS Combine Display, Console, and
Control Handle
1.
Lower the header to desired cutting height or ground
pressure setting. The float indicator box should be set
to 1.5.
2.
Hold the left side of header raise and lower switch (A) until
you hear a ping.
NOTE:
You can set two different cutting heights.
Setting the Sensitivity of the Auto Header Height Control
–
CLAAS 600 and 700 Series
The sensitivity adjustment controls the distance the cutterbar must travel up or down before the auto header height
control (AHHC) reacts and raises or lowers the feeder house. When the sensitivity is set to maximum, only small changes in
ground height are needed to cause the feeder house to raise or lower. When the sensitivity is set to minimum, large
changes in the ground height are needed to cause the feeder house to raise or lower.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1003736
A
B
Figure 9.163: CLAAS Combine Display, Console, and
Control Handle
1.
Use control knob (A) to highlight HEADER/REEL icon (B),
and press control knob (A) to select it. The HEADER/REEL
dialog box opens.
2.
Select HEADER icon.
