![background image](http://html.mh-extra.com/html/macdon/d1-series/d1-series_unloading-and-assembly-instructions_685658234.webp)
215184
210
Revision A
1029413
A
Figure 7.12: Multicoupler on Float Module
4.
At the multicoupler, connect the cab draper extension
harness (MD #304211) to the float module as follows:
•
Connector C3A
–
If the In-Cab Side Draper Speed
Control kit has been installed, plug connector C3B on
the valve drive harness into connector C3A. If the In-
Cab Side Draper Speed Control kit has not been
installed, leave C3A unconnected.
•
Connector C5B
–
Plug connector C5B (A) into
connector C5A on the completion harness.
NOTE:
Connectors C3A and C5B are shipped with caps. The caps
need to be removed in order to connect these connectors.
1009866
A
Figure 7.13: Switch Harness Routing
5.
Route cab draper extension harness (A) along the side of
the combine feeder house to the underside of the
combine cab.
1008141
A
B
Figure 7.14: Left Side of Feeder House
6.
Use cable ties (MD #16661) to fasten cab draper extension
harness (A) to the main harness on the left side of the
feeder house and under the cab floor at locations (B).