215184
176
Revision A
1029491
A
Figure 6.3: Top Gasket
3.
Remove top gasket (A) for use in the next step.
NOTE:
There are two gaskets
—
one on each side of the filler
strainer flange.
1029496
A
B
Figure 6.4: Filler Cap Neck
4.
Place gasket (A) (removed from the top of the filler
strainer) onto filler cap neck (B) and align holes.
5.
Install #10-32 screws (if supplied with cap, otherwise use
existing screws) into filler cap neck (B) and push screws
through gasket (A).
1029452
A
1
2
3
4
5
6
Figure 6.5: Screw Hole Locations
6.
Place filler cap neck (A) (complete with screws) over
opening and ensure the machine screws are aligned with
the threaded holes.
7.
Carefully thread in the machine screws using a cross
pattern (as shown) in order to prevent cross threading of
tapped holes.
8.
Repeat pattern to gradually tighten screws to 3.5 Nm
(31 lbf·in).