78
When the required parameters are not able to fit in one SMS command message, you can
start a new, by using the
PW=
password authentication at
first, then you can continue by
the next parameter or command. You always have to use password authentication, in every
parametring message the
RESET
command as the last!
The command messages can be sent one-by-one, each after then the device will get and
processed them in a time order sequence. Take consider that the device will restarted at
every RESET command, which with all the sent parameters and commands can all cause
minutes to wait while the whole configuration will be finished. Always wait while the device
will be ready for proper usage and signalling of the incoming events.
The parametrisation can be performed due to the parameter names and values which have
been described in the chapter 5 and 6.
You can found some examples for some more complex parameter command SMS messages
in the following.
1.
GSM transmiter (pre-configured for this operation mode by general)
: The
alarm system is connected to the TIP-RING input port, the received CID codes are forwarded
through the GSM network and signalling to the remote dispatcher centre.
PW=ABCD,GPRSEN=0,SYS1=1,ACCOUNT=1130,LFGSMFREQ=60,DTMFTIME=60,RESET
2.
Signalling and trasmigging to an Enigma IP-receiver
: The alarm system is
connected to the TIP-RING input port, the received CID codes are forwarded through the
GPRS network by the Enigma protocol and signalling to Enigma IP receiver.
PW=ABCD,GPRSEN=1,SFUNCT=1,BACKUP=1,SYS1=1,ACCOUNT=1130,LFFREQ=300,LFPRES=1,
APN=NET,SERVER1=89.133.189.139,PORT1=9999,IPPROTO=UDP,IOGPRS=1,RESET
3.
GPRS transmitting to the dispatcher centre
: The alarm system is connected to
the TIP-RING input port, sabotage switch monitoring connected to the input line, the
incoming received signals are converted to Contact ID codes and they are transmitted
through the GPRS network for the remote dispatcher centre IP address.
PW=ABCD,GPRSEN=1,SFUNCT=1,BACKUP=1,LFFREQ=300,LFPRES=1,APN=NET,SERVER1=89.1
33.189.139,PORT1=9999,SERVER2=10.197.251.10,PORT2=8010,IPPROTO=TCP,SWPROTO=
2,RESET
