25
Then the
Easy 2
password will be restored and recovered to the
ABCD
default value.
Monitoring the serial port messages:
At the 4th tab, at the
Serial Monitoring
, you
can
Open
it, and connect to the device in
surveillance (read only) mode, when only the
left side of the window is active with the signal
strength data and terminal window messages.
This feature is provided for monitoring,
checking the
Easy 2
current operation without any intervention or configuration change. Further
details on the Chapter
4.4
.
When you are attempted to
Close
the monitoring, after all you should click to the
Serial
Port
tab,
for connecting the device for parameter configuration.
4.3 Status and device data
In the
Statusz
window
(2) you will receive
the device identifiers as IMEI number (GSM
modem identifier), ICC (SIM card identifier),
HW ID (
Easy 2
unique hardware ID), SW VER
(firmware version), IP ADDR. (modem IP
address on the network).
At the right side of the status window, the
CSQ value is listed (signal strength and its
graph), with the following 3 statuses:
PIN STATE
–
SIM PIN status
(
grey
, when there is no available data;
green
when the PIN code was accepted by the
device)
GSM STATE
–
GSM connection status (
grey
, when there is no available data;
yellow
when the connecting is in progress;
green
when the network connecting of the device
was succesfully performed;
red
when the connection was refused)
GPRS STATE
–
GPRS connection status (
grey
, when there is no available data;
yellow
when the connecting is in progress;
green
when the network connecting of the device
was succesfully performed;
red
when the connection was refused
)
The
GSM state
or the
GPRS state
are always signing the current and exact connection status and
informs about the used protocol on the mobile network. Furthermore, the device statuses can be
Refresh
ed (by its button).
