60
The
ARMON
and
ARMOFF
parameters are for defining the SMS notification messages for
the
arming on
and
arming off
events. The
ARMFAIL
equals with the unsuccesful
arming/disarming event SMS notification message.
By the
ARMBLOCK
parameter, you can
enable
that only the arming will be allowed only for
the closed zones (and for the sensors with closed status)
–
which can be reasonable by
safety needs.
When there is an opened zone during performing an ARM event (arm pushed), then the
ARMFAIL
message will be notifies the persons with the opened zone number and partition
nr.
The
DOALLDIAL
parameter is for
enabling
that in case of an incoming event signal call the
pre-defined phone number(s). It is working together with the
CALLBARTIME1
, and
CALLBARTIME2
, and
CALLTOKENS
parameters regarding its values.
In case of neccessary you can save the configuration to your computer by the
Save file
button.
Please, also check the Chapter 5.6
5.5 Monitoring input lines and gate opening settings
In this operation mode the
Easy 2
is operating very similar to the mode which have been
described at the Chapter 5.4, but the signaling is not performed to the dispatcher centre. In
this mode, the GPRS network is used for remote control of the output lines, and the GSM
network is utilized for messaging, for calling. The further settings can be important to check
or to modify in case of neccessary.
Input settings
Load the factory default .CFG file by the
Browse
button.
For
configuring the
input lines operation
open the
Input Settings
parameter group at the
Device Type
. Then the program will load the related parameters.
Here you can define values only for the input line nr. #1 and #2. The IO-expansion settings
will be listed later.
