52
At the
APN
value, you have to define the APN name for the SIM-card related GPRS data
package service. When using a username or password are needed for the access
–
e.g. in
case of chap authentication
–
then define the
UN
and
PWD
values based on the information
proven by your mobile service provider.
When you would like to use a DNS or DDNS server, you can allow it by the
DNS1
,
DNS2
)
parameters in the next format
–
e.g.
wmsupport.dyndns.org
GPRS transmittins settings
Open the
IP-GPRS Service
parameter group at the
Device Type
. Then the program will
load the related parameters.
At the
SERVER1
parameter fill the primary IP address of the IP-receiver and the
PORT1
value for the port number. Setup the secondary IP address to the
SERVER2
and its port to
the
PORT2
(if it is also necessary).
Change the
IPPROTO
protocol’s format to
TCP
and the
SWPROTO
communication format
to
M2M
which means the modified, special Contact ID protocol. This can be used only with
the Enigma II, Enigma IP2 receiver devices, Alarmsys and SIMS dispatching software).
If you’ve changed one of the listed parameter values, then the program will highlight the
changed value lines by
bold
. For sending the listed parameter values for the device
(regarding the
Selected
coloumn)
–
check the proper selection
–
push the
Write config
button at the bottom of the screen. At the end of the parameter sending, the device is
restarting by using the new settings.
