®
GRAFIK Eye
®
QS Control Unit Installation and Operation Guide 43
Associating IR receivers through a QS Sensor Module (QSM):
1.
Upon power up, the QSM will automatically detect and
configure wired IR receivers after a valid signal is received.
Use an IR remote to send a signal to all connected receivers
in the system.
2.
Enter programming mode on the GRAFIK Eye
®
QS control unit.
3.
Use the Master buttons to highlight “IR Setup” and press the
“OK” button to accept
4.
Use the Master buttons to highlight “Programming” and
press the “OK” button to accept. The info screen will display
“Searching” while the unit detects available infrared receivers.
5.
Use the Master buttons to scroll through the list of available
infrared receivers (the displayed IR receiver will flash). When the
desired IR receiver is displayed, press the “OK” button to select
it. Press the “OK” button again to continue.
6a.
To assign the IR receiver as a zone controller, use the Master
buttons to select “Zone” and press the “OK” button to accept.
Use the zone raise/lower buttons for a zone to select a desired
preset level, then press the zone raise and lower buttons
simultaneously for 1 second (until the zone LEDs flash at the
programmed preset level). Repeat for all zones you wish to
control with the IR receiver.
OR
6b.
To assign the IR receiver as a scene controller, use the Master
buttons to select “Scene” and press the “OK” button to accept.
Press and hold the top scene button on the GRAFIK Eye
®
QS
control unit for 3 seconds (until the scene LEDs flash).
7.
Press the Timeclock (back) button twice to return to the list of
available IR receivers and repeat as needed.
8.
Exit programming mode on the GRAFIK Eye
®
QS control unit.
IR Setup (continued)
Saved
Searching...
Main menu
Wireless Mode
IR menu
Integral IR
IR Setup
Programming
IR Setup x/y
xxxx-xxxx
QS
1
QSM
Change Type?
Press OK
Change type?
Zone
Change type?
Scene
Saved
Saved
Zone LEDs
Zone Raise
Zone Lower
OK
Press and
hold the
top scene
button for
3 seconds
to assign
IR receiver
as a scene
controller.
Master
buttons
“OK”
button
QS Sensor
Module (QSM)
Wired IR
Receiver
