Step by Step Instructions for GRAFIK Eye Dimming Panel
23
Wallstations and
Control Interfaces
Repeat for all Wallstations
Make Control Unit “Listen”
Press and hold another Control Unit’s Scene 1 button until its LEDs flash. To make it
stop “listening”, hold OFF button until LEDs go dark.
Press and hold Scene 1 on a Control Unit until its LEDs blink in unison. Repeat Scene 1
hold procedure for the other Control Units to be affected. (To remove, hold OFF button
until LEDs go dark
Press and hold Scene 1 on a Control Unit until its LEDs flash. To make it stop “listening”,
hold OFF button until LEDs go dark.
Choose two Control Units on either side of a Partition. Press and hold Scene 1 on a
Control Unit until its LEDs flash. Repeat Scene 1 hold on the other Control Unit. Press
the next button on the NTGRX-4PS. Choose another pair of Control Units. Repeat Scene
1 hold procedure for each of the NTGRX-4PS buttons. To remove, hold OFF button on
each Control Unit until LEDs go dark.
Choose a Control Unit to be toggled by the NTGRX-4M. Press and hold Scene 1 on the
Control Unit until its LEDs flash. Repeat Scene 1 hold on other Control Units to be
toggled. Press the next button on the NTGRX-4M. Choose a Control Unit to be toggled.
Repeat Scene 1 hold procedure for all 5 of the NTGRX-4M buttons. Button 5 only turns
ON or OFF (it does not toggle). To remove, hold OFF button on the Control Unit until its
LEDs go dark.
Press and hold Scene 1 on a Control Unit until its LEDs blink in unison. Repeat Scene 1
hold procedure for the other Control Units to be affected. (To remove, hold OFF button
until LEDs go dark.
Press and hold Scene 1 on a Control Unit until its LEDs blink in unison. Repeat Scene 1
hold procedure for the other Control Units to be affected. (To remove, hold OFF button
until LEDs go dark.
See above instructions for the simulated Wallstation.
Take Control Out of Set-Up Mode
Press and hold first and fifth buttons of the original GRX-4000 Series Control
Unit until LEDs stop sequencing.
Press and hold first and fifth buttons on Wallstation until all LEDs stop
cycling.
Press and hold first and fourth buttons on Wallstation until all LEDs stop
blinking
Press and hold first and fifth buttons of the NTGRX-4PS until all LEDs stop
blinking.
Press and hold first and fifth buttons of the NTGRX-4M until all LEDs stop
blinking.
Press and hold both buttons of the NTGRX-2B-SL or EGRX-2B-SL until all
LEDs stop blinking.
Press and hold both buttons of the NTGRX-2B-SL or EGRX-2B-SL until all
LEDs stop blinking.
If the GRX-AV’s LEDs are sequencing, press and hold the Program Switch until
the LEDs stop sequencing. If the GRX-AV has 1 LED blinking, press the
program switch repeatedly until there are no blinking LEDs.
