Lupus Electronics LUPUSEC-XT2, Руководство пользователя

Страница: 86 / 148

86
ENGLISH
and be displayed in the control unit.

If no audio signal sounds, the control unit was not able to receive the keypad
signal.

If the keypad is found, three short signals sound.
4.
Add the keypad to the control unit.
5.
Perform the range test. Start the range mode of the control unit and take the
keypad to its place of installation.
6.
Enter the sequence * + 7 in the keypad.
7.
The control unit should display the actual signal strength.
8.
To exit the installation mode , press the “Open lock key” twice. Only then, you
can arm and disarm the XT2 with the keypad.
The keypad emits a signal and the Power LED goes off after a short while.
Change PIN code to arm/disarm/home:
Go to Home  PIN codes to change these codes.
Change alarm system status with keypad:
1.
Arm:
User PIN (default 1234) + Arm (one long signal sounds and the red Status LED
lights up).
2.
Disarm:
User PIN (default 1234) + Disarm (two signals sound and the blue Status LED
lights up).
3.
Enable Home mode:
User PIN (default 1234) + Home and then 1, 2, or 3 to activate the required Home
mode (three signals sound and the red Status LED flashes four times). If you press
no number after the home mode button, Home mode 1 is activated automatically.
Note:

The activation of different home modes is possible only with firmware 0.0.2.7M
and higher and a keypad bought in September 2014 (or later).

The keypad can control both areas (firmware 0.0.2.7M and higher), depending on
which PIN code (Area 1 or 2) is used.

If a system error is displayed (the third LED flashes), you can usually ignore it by
activating the Arm/Home mode again within ten seconds. You can see and ignore
the current system errors in the XT2 via “Control unit”
 “Status”  “XT2 Status”.

Alternatively, you can configure the control unit so that the status is always
changed irrespective of system errors via “Settings”
 “Control unit”  “Area” 
“Arming with error”

“Confirm” switch to “Force arming”.

The keypad transmits its status “only” upon entry. That is the reason why you can
see that the batteries are low, but not that they are empty!
Activate dual key functions:
The keypad can trigger a hold-up (panic) alarm, fire alarm, or medical emergency
alarm by means of predefined shortcuts. Once activated, these shortcuts can be
used
without entering the PIN code ! To activate the dual keys, please proceed as
follows: