Lupus Electronics LUPUSEC-XT2, Руководство пользователя, Страница: 90 / 148

90
ENGLISH
4 x dowels
4 x 1.5 V D alkaline battery
Put the wireless in door siren into operation
1.
Remove the bottom of the wireless indoor siren by unscrewing the screw at the
bottom.
2.
Unscrew the four battery compartment screws and insert the supplied batteries. A
brief signal sounds.
3.
A blue switch bay with altogether seven switches is located in the middle of the
electronic component. By default, they are all set to OFF (down).
4.
The following table lists the functions of the switches:
SW1 Mode to add the siren to the control unit
OFF Off
ON On
SW2 Not occupied
SW3 SW4 Alarm duration
OFF OFF 3 minutes
ON OFF 5 minutes
OFF ON 10 minutes
ON ON 1 second (Test mode)
SW5
Not occupied
SW6 Reset memory
OFF Normal
ON Deletes memory
SW Sends a status signal to the control unit
OFF Off
ON On
5.
Start the control unit’s configuration page, open the menu “Sensors”  “Add” and
click on “Start”.
6.
To put the wireless indoor siren into operation, set SW1 from OFF to ON. The
wireless indoor siren sends a brief signal for confirmation.
7.
The control unit will now detect the wireless indoor siren and list it under
“Detected sensor”. If the siren is not found, repeat step 6.
8.
Click on “Add”. If you want to change the siren settings (name, area, zone), click
on “Change”.
Note:
If you want to assign the siren to both areas, activate the “All areas” option. If you
want to change this option or the area of the siren later, the SW1 switch in the siren
needs to be set to ON again!
9.
Set SW1 back to OFF .
10.
Test the siren function by simulating an alarm or actuating the tamper contact.