Lupus Electronics LUPUSEC-XT2, Руководство пользователя

Страница: 128 / 148

128
ENGLISH
Status signal
If SW5 is set to ON, then the wireless sensor input transmits a status signal to the
control unit every 30 to 50 minutes. If the control unit does not receive the signal, it
will alert.
Put the wireless sensor input into operation:
To put the wireless sensor input into operation, proceed as follows:
1.
Insert the supplied batteries.
2.
Define the function with switch SW 1-4.
3.
Connect the contact to the required potential-free switch contact.
4.
Close the housing.
5.
Open the configuration page of the control unit, open the menu “Sensors”  “Add”
and click on Start.
6.
Press the test button of the wireless sensor input for about one second.
7.
The configuration page of the control unit should list the wireless sensor input.
8.
Add the wireless sensor input.
9.
You can test the signal strength in the Range menu. For that purpose, go to the
intended place of installation, press Range test
 Start in the control unit menu
Sensors  Range and then press the Test button of the wireless sensor input. The
higher the indicated number the better the reception (1-9).
SW1 Door contact (DC-11C2)
ON Activated (default)
OFF Deactivated
SW2 Motion detector
ON Activated
OFF deactivated (default)
SW3
Smoke detector
ON Activated
OFF deactivated (Default)
SW4
Panic button
ON Activated
OFF Deactivated (default)
SW5 Status signal
ON Activated (default for 868NF))
OFF Deactivated (default for 868WF)
SW6
CON4 NO/NC
ON Normally open (NO)
OFF Normally closed (NC default)
SW Shutter
ON 5 pulse / 10 sec
OFF 3 pulse / 10 sec (default)
SW8 Reserved