Lupus Electronics LUPUSEC-XT2, Руководство пользователя

Страница: 85 / 148

85
ENGLISH
Note:

In normal operating mode, all LEDs are off.

If a key is pressed, the Power LED lights up for 5 seconds, thus signalling
operational readiness.

Status LED (Check system status of control unit with keypad):
If you press the Status

key on the keypad, the status of the control unit is checked.
Soon after, the Status LED indicates the status:
Red LED lights up: System is armed
Red LED flashes: System is in Home mode
Blue LED lights up: System is disarmed
Blue LED flashes
 error
o
No response from control unit
o
Incorrect PIN code
o
Home activated in armed (away) mode
o
Arming forced despite sensor failure reports

Error LED:
Orange LED flashes: system error, e.g.
o
No SIM card
o
GSM not ready
o
Open tamper contact
o
Control unit power failure
o
Sensor out of range
o
Open sensor
o
Sensor battery low

Battery:
The keypad requires a 1/2 AA 3 V 850 mAH lithium battery. The average battery life
is two years. If the battery is low, the orange Status LED on the keypad flashes.
Put keypad into operation
Installation of keypad:
1.
Remove the front cover from the keypad by unscrewing the lower screw.
2.
Use the two screw holes to mark the drill holes at the wall.
3.
Fasten the keypad.
4.
Attach the front cover.
Add keypad to control unit:
1.
Open the installation mode by entering the PIN code of the keypad (default 0000)
and then pressing the
* key. The Power LED will light up in orange.
2.
Open the main menu of the control unit and then the sub-menu “Sensors” 
“Add”. Click on Start.
3.
Enter the sequence * + 7 in the keypad. The keypad should emit a signal sound