Lupus Electronics LUPUSEC-XT2, Руководство пользователя

Страница: 102 / 148

102
ENGLISH
control unit.
Note:
In the sensor properties of the remote control, you can assign predefined rules to the
different buttons. You can e.g. define a rule to activate the Home mode 2 or 3 (the
chapter “Automation” describes the rules).
Medical emergency controller
Product description:
Alarm button:

If the alarm button is pressed for more than one second, the
control unit triggers an alarm.

If this button is pressed for more than eight seconds during
the alarm, the alarm is deactivated.

The LED illuminating confirms this.
Put the medical emergency controller into operation
1.
Start the XT2 configuration menu and open the window “Sensors”  “Add”. Then
press „Start“.
2.
Press the alarm button of the medical emergency controller.
3.
The control unit should then indicate the medical emergency controller after a
short while. Add it to the control unit.
Battery:
The medical emergency controller requires a CR2032 3 V lithium button cell. The
average battery life is approx. four years.
Activate battery status indicator:
If required, you can activate the battery status indicator. For this purpose, press the
alarm button for minimum 15 seconds and ignore the LED signals at one and eight
seconds.
The LED will flash three times after 15 seconds. From then on, the medical
emergency controller will transmit the battery status to the control unit every 24
hours. If the battery runs low, the control unit will be informed.