Lupus Electronics LUPUSEC-XT2, Руководство пользователя, Страница: 35 / 148

35
ENGLISH
o
Click on “Confirmation signal off”
o
Then click on “Apply device” below
Note:
If the tamper contact of the siren is open when arming the system, five short acoustic
signals sound even though the confirmation signal is disabled.

Entry signal on/off
With this function active, the siren will sound confirmation signals for the duration of
the defined delay until the system is armed.
To disable the warning signal of the siren(s) upon entry/exit, proceed as follows:
o
Click on “Entry signal off”
o
Then click on “Apply device” below
Note:

These three settings are transmitted only and not permanently stored in this menu.
After they were transmitted, all three settings are ON again - but they were stored
in the sirens, after they transmitted the confirmation signal.

In addition, please note that the configuration is sent to all currently connected and
active external sirens. If you want to configure several sirens differently, you
should delay the installation of these sirens or just disconnect these sirens from
the power supply while the settings are changed. It is impossible to read out the
current siren configuration.
Advanced settings
A siren, which is currently being developed, will support the following advanced
settings (presumably available in 2015):

Area
Enter the area, in which the siren is located.

Zone
Enter the zone number of the siren, the settings of which you want to change.

Alarm volume
Define the siren volume in case of alarms.

Door bell
Specify, whether the siren is to give an acoustic signal with the “Doorbell function”.

Trigger alarm in “Home” mode
Specify, whether the siren is to trigger an alarm in case of a burglary with the control
unit in Home mode.

Trigger alarm in “Arm” mode
Specify, whether the siren is to trigger an alarm in case of a burglary with the control
unit in Arm mode.

Siren strobe
Specify, whether the siren is to flash in case of alarms.