Lupus Electronics LUPUSEC-XT2, Руководство пользователя, Страница: 87 / 148

87
ENGLISH
Start the Test mode by entering the installer PIN code of the keypad (default 0000)
and then pressing the * button. The Power LED lights up in orange.
In the Test mode, press the following keys to activate the respective functions:
Activate dual key functions 1+3 (panic alarm): * + 2
Activate dual key functions 4+6 (fire alarm): * + 3
Activate dual key functions 7+9 (emergency alarm): * + 4
Activate all dual key functions: * + 5
Note:
You can define in the sensor properties of the keypad, which action to take, when you
press the shortcuts (1+3, 4+6, 7+9). You can e.g. define a rule to activate the Home
mode 2 or 3 (chapter “Automation” describes the rules).
Additional optional settings in Test mode:
Add the keypad to the control unit: * + 7
Change the installation PIN code: *+6
1.
Enter the current PIN code (default 0000).
2.
Press the Status

button. A long signal sounds.
3.
Enter the new four-digit PIN code.
4.
Press the # button to save the new PIN code.
Activate Arm/Home without PIN entry: * + 8
Activate Arm/Home with PIN entry: * + 9
To
exit the installation mode , press the “Open lock key” twice.
If you forgot your PIN code, you can reset the keypad to the
factory settings .
For this purpose, proceed as follows:
1.
Open the housing, making sure not to trigger the tamper contact.
2.
Remove the batteries.
3.
Press and hold pressed the button 3, while you reinstall the batteries.
4.
Release the button 3.
After the
Reset , the installer PIN code is set to default 0000.