Luma Surveillance LUM-500-DVR-16CH, Техническое справочное руководство

Страница: 21 / 217

Luma Recorders
|
Additional Installation
Jump to Main TOC 21 Jump to Additional Installation
Installing a PTZ Camera with RS-485
Use these instructions to attach Wirepath Surveillance analog PTZ
cameras to your Luma recorder.
Connecting to a DVR
Connect the BNC cable from the PTZ camera to the DVR.
Connect the RS-485 cable from the PTZ camera to the RS-485
connection on the DVR (T+ and T-).
Power on the PTZ camera. You should see video in channel assigned
to the camera.
Go to Configure This Recorder > Camera Settings > PTZ Settings
and set parameters accordingly.
To use the PTZ controls, select the DVR channel that the PTZ
camera is on and click on the PTZ icon above the timeline bar. If
everything has been set up correctly, you will have control over the
PTZ camera (see the PTZ camera manual for how to set the DIP
switches to change your baud rate or protocol).
Connecting to an NVR with a WPS Encoder
Use these instructions for 1- and 4-channel encoders.
Connect the encoder to same network that the NVR is on. Do not
connect it to the POE switch on the NVR.
Discover the encoder with the Wirepath IP Installer and give it a
static IP address.
Go to Configure the Recorder > Camera Management > IP Camera .
Click the Quick Add button, then select the IP address of the
encoder in the same way that you would an IP camera. Press
OK .
Select the encoder in the device list, then click the Modify button.
Ensure that the protocol is set to Wirepath, the transfer protocol is
auto, and the adding method is manual. Check your port settings,
camera name (you can create any name), user name, and password.
Ensure that the baud setting matches the camera and the NVR
(the baud on the camera can be changed using the camera’s DIP
switches; see the camera’s manual for complete details).
If you have multiple cameras using a single 4-channel encoder,
please see the additional instructions below at this time.