Luma Recorders
|
Additional Installation
Jump to Additional Installation
Line up the holes in the mounting bar over the drives, then use four
of the screws supplied with the recorder to secure each drive in
place.
You may wish to use a permanent marker to number each of the
drive bays in case you replace a hard drive at a later date.
Reinsert the Mounting Bar
Replace the mounting bar with the drives in the recorder. First insert
the front of the mounting bar by angling it downward and sliding
over the notches in the support pegs, then set the rear end of the bar
down.
Re-install the screws on the outside left and right of the case to lock
the mounting bar in place.
Connect the Drives
Using the extra SATA cables provided with the recorder, connect
each hard drive to the mother board.
Be sure to connect them in the correct order. Looking at the recorder
from the front of the unit, the SATA ports are numbered 1–4 from
Содержание LUM-500-DVR-16CH
