Configuring the unit
DSLPipe/CellPipe Quick Setup
DSLPipe/CellPipe Quick Setup
3-17
Changing the SDSL rate
The DSL-HSTB unit ships with the default SDSL rate of 2320 Kbps. You can use any
one of the following rates:
•
144 Kbps
•
272 Kbps
•
400 Kbps
•
528 Kbps
•
784 Kbps
•
1168 Kbps
•
1552 Kbps
•
2320 Kbps
. To change the SDSL line rate, enter the following:
lucent% set sdsl rate <Kbps> (Press the Enter key)
Autohunt option
The DSL-HSTB unit is automatically set to hunt for the line rate. The unit tries
different rates to sync up with the COE site. Depending on the rate set at the COE
side, this might take a few minutes.
To force the DSL-HSTB unit to connect at only a specified speed, you can set the
autohunt option to off. Type the following:
lucent% set autohunt off (Press the Enter key)
Exiting the command-line interface
To exit the command line interface, type exit at the prompt:
lucent% exit
