DSLPipe/CellPipe Quick Setup
2-1
2
Getting ready to configure
Most of the DSLPipe/CellPipe units share the same user interface window and are
configured in a similar way. The DSL-Cell-20A and the DSL-HSTB units, however,
are bridging-only units and allow for very limited software configuration.These two
units display a different command-line interface. To view or change the configuration
for these two units, see “Configuring the DSL-Cell-20A” on page 3-8 and
“Configuring the DSL-HSTB unit” on page 3-13
Getting ready to configure the DSLPipe or
CellPipe unit
Before you can configure your DSLPipe/CellPipe unit, you must establish a serial
connection to the unit.
Items you need
•
You need a serial cable that can plug into an available, enabled serial port on your
computer. The other end of the cable must have a male DB-9 connector to fit the
serial port connector on the back of the DSLPipe/CellPipe, or it must fit into the
supplied DB-25 to DB-9 adapter. If your computer is a Macintosh, the cable must
fit the modem port’s nine-pin mini DIN connector.
•
You also need communications software that supports VT100 emulation.
