Configuring the unit
DSLPipe/CellPipe Quick Setup
DSLPipe/CellPipe Quick Setup
3-3
Plug and Play capability
The Ascend Plug and Play is a set of features that allows you to set up your DSLPipe
quickly and easily. The Plug and Play feature is automatically enabled in your
DSLPipe. The Plug and Play capability is based on a default Frame Relay
configuration and a DHCP client. The DHCP client in a DSLPipe automatically
performs the appropriate DHCP protocol procedure to get its configuration
information. The DSLPipe automatically receives its IP address, netmask, default
gateway, and TFTP server address from the remote device.
Note:
To see if you can use the DSLPipe plug and play capability, check with your
service provider.
Changing default configuration of DSLPipe units
If you cannot use the plug and play capability, you must modify the predefined
settings to create your own connection profile(s).
Note:
This section does not apply to the DSL-HSTB unit. For details on changing
the configuration of the DSL-HSTB unit, see “Configuring the DSL-HSTB unit” on
page 3-13.
Creating a connection profile for a Frame Relay connection
To create a connection profile for Frame Relay, you must, at a minimum, do the
following:
1
Assign values to the following in the Configure menu:
My Name =
My Addr =
Rem Name =
Rem Addr =
Route =
Bridge =
2
Choose Configure > Ethernet > Connections and verify that Encaps = FR.
3
Choose Configure > Ethernet > Encaps options... and assign values for the
following:
