
Configuring the unit
DSLPipe/CellPipe Quick Setup
3-8
DSLPipe/CellPipe Quick Setup
Configuring the DSL-Cell-20A
The DSL-Cell-20A unit performs bridging over ATM with LLC encapsulation. It
ships with a default VPI of 8 and a default VCI of 35. If you do not need to change
these default settings, just plug in the cables and you are ready to use the
DSL-Cell-20A unit.
DSL-Cell-20A command-line interface
After you connect the cables, and set up the communications software (see “Getting
ready to configure the DSLPipe or CellPipe unit” on page 2-1), the following appears
on your VT100 terminal:
Boobase Version: <Version Number> <Date and Time>
RAM Size = 4096 bytes
DRAM POST: Testing: 4096 OK
FLASH: Intel 8M*1
ZYNOS Version: <Version Number> <Date and Time>
Press any key to enter debug mode within 3 seconds...
Version: <Version Number>, start: <hex address>
Length: <hex number>, Checksum: <hex number>
Compressed Length: <hex number>, Checksum: <hex number>
Initialize ch=0, Ethernet address: <MAC addresss>
Loading AADSL modem F/W
..................................................
WAN Channel init...don
e
Press ENTER to continue...
From the VT100 emulation screen, press the Enter key to see the lucent prompt.
The
lucent%
prompt appears.
Displaying status
To see the list of all the status commands available, type the following:
lucent% show atm ?