Installing the unit
DSLPipe/CellPipe Quick Setup
DSLPipe/CellPipe Quick Setup
1-7
Steps to setting up your DSLPipe/CellPipe unit
To set up your DSLPipe/CellPipe, perform the following steps:
Step
Description
Go to page
1
Check DSLPipe/CellPipe model. The model name
is printed on the bottom of the DSLPipe/CellPipe
box.
2
Connect the cables as required for your
DSLPipe/CellPipe model.
•
If you are connecting to an Ethernet hub and
you are not using the DSL-HS or the
DSL-HST model, you must supply your own
straight-through cable.
•
To configure the DSLPipe/CellPipe, you must
supply your own serial cable.
page 1-10, page 1-12,
page 1-14, page 1-16,
page 1-18
page 1-20
3
Check the activity of DSLPipe/CellPipe LED
lights.
4
If you are configuring:
•
a DSLPipe unit, read the description of the
default configuration.
•
the CellPipe 50A or the CellPipe 50S, read the
information on configuring these pipes.
•
the CellPipe 20A, read the desciption of the
default configuration.
5
To change the default configuration, see the
sample scenarios.
Before you can change the configuration, you must
establish a serial connection between your
workstation and the DSLPipe/CellPipe unit. You
must also have software for vt100 emulation.
page 3-18 (Also see
page 3-8 and
page 3-13)
