Chapter 10 Program Examples
10-33
▶
P2P Block setting
Setting of PLC 1
Sequence
Setting method
1
1. Double-click P2P block of P2P 02
2. Input channel which (user definition frame) was selected in the P2P channel.
3. In P2P function, in case of transmission frame, select SEND and in case of reception frame, select
RECEIVE.
4. Conditional flag is activated when P2P function is SEND.
5. Since first frame of PLC 1 is transmitted every 2 seconds, input F92.
6. Select frame referring to frame name of PLC 1 in above frame structure.
7. Since send3.c is sent when receiving ‘b’, input L010150 which means completion of receiving first data
of P2P 2 as conditional flag
Setting of PLC 2
2
1. Referring to above frame, input P2P block like step 1
▶
Writing parameter
Refer to writing parameter of 10.1.2
Содержание XGL-C22A
