Standby battery socket
Anti-tamper switch
Standby battery switch
Antenna Standby battery
Bell output
Wired zone Z1
Wired zone Z2
10.3 Telephone arm-stay
After picking up the telephone, press '# +4digits password(user
password, operation password) + 2 + #' to arm, For example, if user
password is 1234, press '#12342#'. When alarm occurs, user has to
disarm first and then arm the system again.
When the control panel dials to alarm, user can press 3 to disarm and
then press 2 to arm after hearing alarm voice.
Wired zone Z3
Wired zone Z4
Password
restore jumper
10.4 Telephone spot supervision
After picking up the telephone, press '# + 4digits password(user
Power input
Relay output
Grounding
Telephone
line input
Telephone
line output
Keypad line slot
password, operation password) + 4 + #' to monitor on the spot. For
example, if password is 1234, press'#12344#'. When the control panel
dials to alarm, user can press 4 to monitor his/her house after hearing
Figure 3 Control panel inside
After wiring close the cover
Figure 4
5.2.1 Power connection
Power Adapter: Input 100V~240VAC 50/60Hz 0.3A, output 12VDC 1A
connect output plug with socket (Refer to the figure 3)
The control panel with 7.2V/1800mAh NH rechargeable battery as
standby battery. In working status and the battery is well charged, it can
supply the system with power more than 14 hours, low-battery, it can
supply power more than 1.5 hours
Low-battery, power indi cator f lashe s fast, when AC power is low-voltage,
power indicator flashes slow .When AC power and standby power is in
working voltage, power indicator switched on .When standby or AC power
is low- voltage buzzer chirps 1 minute
-4-
voices. The control panel will not dial any other numbers.
The spot supervision time is about 30 seconds, this status will be over
after hearing the prompt voice 'Di', and user can operate continually in
ten seconds.
10.5 Hearing present alarm type
After picking up the telephone, press '# + 4digits (user password,
operation password) + 5 + #' to hear present alarm type. For example, if
user password is 1234, press '#12345#'. The control panel will play the
alarm voices 5 times and pause 5 seconds among them. If no key is
pressed, the system will hang up automatically. If no alarm occurs, user
can hear 'Di-' twice.
When the control panel dials to alarm, press 5 to hear alarm type. The
system will play the alarm voice 5 times and pause 5 seconds among
them. If no key is pressed, the system will hang up automatically.
10.6 Hang-up/stop alarm dialing
When the control panel dials to alarm, user presses '0' after hearing
alarm voice, the control panel will hang up automatically and not dial any
other numbers.
When dialing via phone, the system can use operation digit '0' to hang up
automatically.
-29-
