9.3.8 Telephone line monitor
Enter : 26X
Note:
If user want to exit program status press '*' to delete digits .When
Operations: (PROG
user password
#)
26
X
#
all digits are deleted, press '*' key to exit. This operation can be realized
by pressing '#' key or one function keys .In the programming status, if
Operations definition:
X=1 (ON)
X=0 (OFF)
The factory default setting is X=1 (ON)
Functions:
When the control panel is not connected with telephone, use this
command to forbid checking the connection of telephone line. Avoid system
trouble voice when user turns on the control panel every time.
without pressing any key for 1 minute, the system will exit present status
and return to display clock and arm/disarm status.
9.3 Basic system programming
To program the system, press PROG user password '#', then enter the
programming status. In this status, setting the system with the command
code without password. LCD displays corresponding status or digits.
9.3.9 Protocol option
Enter: 27X
Operations: (PROG
user password #) 27
X #
9.3.1 Communicator programming
Enter: 11 XY...Y
Parameters definition:
X=1 (4+1 Protocol)
(1) Set alarm phone number
X= 0 (Contact ID Protocol)
Operations: (PROG user password
#)
11
X Y...Y
#
The factory default setting is X= 0 and supports
Contact ID Protocol.
Functions:
The control panel supports 4+1 and Contact ID communication
Protocol.
Parameters setting:
X=1~6, indicates 1~6 groups telephone, 1 is alarm
number of the center stations, 2~6 are personal telephone numbers. Y...Y:
indicates telephone number, telephone number is null in factory default
setting.
Functions:
The system can be set 6 groups of alarm telephone number. NO.
9.3.10 Relay output type setting
Enter: 28 X
1 is for the center stations. If alarm happens the system will call center
stations and sent out alarm information using ADEMCO protocol to the
center stations. If there is no center stations service, the system begins to
Operations: (PROG
user password
#)
28
X
#
dial number from NO.2 according to the alarm information set. If user does
Parameters setting:
X=1: alarm output
X=2: fire alarm output(the factory default setting)
not deal with alarm information, the system will continually dial the telephone
number for 30 times. (Refer to remote telephone operation)
For example:
if user wants to set NO.2&3, operation as followed: PROG
X=3: arm output
User password
#
11
2
telephone number
#
11
3
telephone
Functions:
Relay output is N.O. If alarm output is set, the relay will close
number
#
when alarm. If fire alarm output is set, the relay will close only fire zone
alarm. If arm output is set, the relay will close when the system in armed
status.
Note:
When duress alarm occurs, the system dial the NO.5 and NO.6
telephone of center stations. Recommended: the fifth and the sixth group of
telephone numbers should not be set as personal mobile phone number.
(2) Alarm telephone number cancelling
9.3.11 Bell/Buzzer chirp times setting
Enter:29 XX
Operations: (PROG
User password
#)
11
X
#
Operations: (PROG user password #) 29 XX #
Parameters definition:
XX=00~30, unit is 1 minute. delay time is among 0~
30 minutes
XX=00 (0 minute no alert)
XX= 01 (1 minute)
-18-
Parameters definition:
X=1~6, indicates 1~6 groups telephone. 1 for the
center stations, 2~6 for personal telephone numbers.
Function:
Cancel telephone number. (Including telephone number of the
center stations)
-15-
