Linksys Voice System Administration Guide
34
Using the Interactive Voice Response Unit
Basic Administration of the SPA9000
•
”Using the IVR Menu,” on page 34
•
”Entering a Password through the IVR,” on page 37
Using the IVR Menu
To use the IVR menu, complete the following steps.
1. Connect an analog telephone to the Phone 1 or Phone 2 port of the SPA9000.
2. Press
****
(quickly
press the star key four times).
3. Wait until you hear “Linksys configuration menu.”
4. Refer to
Table 2-1
to identify the option required.
5. Enter the required option followed by the # (pound) key.
NOTE:
•
To enter a period, use the star key (*).
•
When entering a value, such as an IP address, to exit without entering any changes,
press the
*
(star) key twice within half a second. Otherwise, the * is treated as a decimal
point.
•
After entering a value, such as an IP address, press the
#
(pound) key to indicate you
have finished your selection.
•
To save a new setting, press
1
. To review a new setting, press
2
. To re-enter a setting,
press
3
. To cancel your entry and return to the main menu, press
*
(star).
For example, to enter the IP address
191.168.1.105
by keypad, press the following keys:
191*168*1*105
. Press the
#
(pound) key to indicate that you have finished entering the
IP address. Then press
1
to save the IP address, or press the
*
(star) key to cancel your
entry and return to the main menu.
•
If the menu is inactive for more than one minute, the SPA9000 times out. You need to re-
enter the menu by pressing ****.
6. To exit the menu, hang up the telephone.
The settings that you have saved take effect after you hang up the telephone. The SPA9000
may reboot at this time.