![background image](http://html.mh-extra.com/html/linksys/linksys-spa9000/linksys-spa9000_administration-manual_1923831157.webp)
Linksys Voice System Administration Guide
155
Router Tab
Router tab > Wan Setup page >
MAC Clone Settings section
Router tab > Wan Setup page >
Remote Management section
Router tab > Wan Setup page >
QOS Settings section
Router tab > Wan Setup page >
VLAN Settings section
DNS Query Mode
The mode of DNS query: parallel or sequential
NOTE:
With parallel DNS query mode, the SPA9000 sends the same DNS
lookup request to all the DNS servers at the same time, and the first
incoming reply is accepted by the SPA9000.
Default:
parallel
Primary NTP Server
The IP address or name of the primary NTP server
Secondary NTP Server
The IP address or name of the secondary NTP server
DHCP IP Revalidate Timer:
Enable MAC Clone Service
Enable if you need to assign a different MAC address to the SPA9000 via
the Cloned MAC Address field.
Cloned MAC Address
The MAC address that you need the SPA9000 to assume
Enable WAN Web Server
Allows (yes) or prevents (no) access to the administration web server
from a computer that is not directly connected to the SPA9000.
Default:
yes
WAN Web Server Port
The port that is used for WAN access to the SPA9000
Default:
80
QoS Policy
The queueing discipline, set to none or token bucket filter (TBF). TBF
limits the rate of transmission to not attempt to exceed the Maximum
Uplink Speed.
QOS QDisc
Allow QoS Queuing. Options are None or TBF (token bucket filter).
Information can be found at about TBF at:
http://lartc.org/howto/
lartc.qdisc.classless.html
Maximum Uplink Speed
Define this value to allow the token bucket filter queueing discipline to
manage traffic flow to ensure high quality voice audio.
Enable VLAN
Enable voice data to be tagged with the defined VLAN ID.
NOTE:
Choose
yes
If your SPA9000 is connected to a switch that uses
VLAN tagging.