![background image](http://html.mh-extra.com/html/linksys/linksys-spa9000/linksys-spa9000_administration-manual_1923831049.webp)
Linksys Voice System Administration Guide
47
Configuring Line Interfaces on the SPA9000
Configuring Phone Lines and Calling Routing Behavior
Password:
The password for your ITSP account
Proxy:
The proxy server for your ITSP account
SPA9000 Voice > Line
NOTES:
•
SIP Port:
You can keep the default value. Each line must have a unique SIP port (5060 for
Line 1, 5061 for Line 2, 5062 for Line 3, 5064 for Line 4).
•
Contact List:
The default value is
aa
, for the Auto Attendant. As a general practice, you
should leave the default value until after you confirm that the line is registered. Then
you can configure the contact list. For more information, see
”Managing Inbound Calls
with the Contact List,” on page 66
.
•
Depending on your ITSP network configuration requirements, you may need to set
additional parameters such as Outbound Proxy. Service Provider will indicate the
setting of any additional parameter for each ITSP line.
5. Click the
Submit All Changes
button. The SPA9000 device reboots.
6. To verify the registration state, perform the following tasks:
•
After the devices reboot, Click
Voice tab > Info
. Scroll down to the
Line Status
section for
the line that you configured (
Line 1 Status ... Line 4 Status)
. Verify that the line is
registered. If the line is not registered, you may need to refresh the browser several
times because it can take a few seconds for the registration to succeed.