Setting the PAN middle position:
The middle position normally is the position in which the installed device is
used most
.
It can be set at menu
P05, PAN-axis middle position
, page 22.
You should start with the pan axis in the
current adjusted
middle position. If you do not
know if this is the case, power up the device and set the DMX-channel for position to 50%.
Do not forget to set the speed value to 100%. Channels are 1 (position) and 5 (speed) at
factory presettings.
The
moving angle
can be set in menu
P11, PAN-axle moving range, page 24
. It can be in
a range within 10 and 160°. Recommended is 90°.
Caution !!
Check the
entire moving
range of the lamp:
The lamp-manufacturer specify
minimum distances
to inflammable materials. Never fall
below the minimum distance in no position of the lamp!
Make sure that no cable will be
broken
,
bended
,
stretched
or
damaged
anyhow by
reason of turning the motoryoke!
16
Motoryoke YipMan1 V4.58 Rev 1.00