Getting started
Mount
the motoryoke system at the desired place with observing the operating and safety
instructions on page 6!
Mount
the moving device like described in
Assembling the device
on page 10.
Cable
the system like described on page 12.
Switch on
the motoryoke. After testing its internal program memory and the control it
shows the overall operating hours. Now the motoryoke is moving to the programmed
position. The second display line shows the DMX-address and value of the PAN-axle.
Caution!
Make sure that the motoryoke is not moved by the
control panel
before programming.
Otherwise the motoryoke will move during programming if the position is changed at the
panel!
Program the
middle position
exactly at the display via P05, refer to
programming the
middle position
on page 22.
Program the
moving range
of the
PAN
-axle. Refer to
P11, PAN-axle moving range, page
24.
Normally not necessary, but possible is the programming of the
TILT moving range
. Refer
to
TILT-axle moving range,
page
.
If you are using a control desk with
joystick
,
vision control
or
LT-Pilot
the speed channel
setup in P27, page 29, must be programmed to 1!
If you are using a standard DMX desk P27
can
be programmed to 1 or 0. Decide for
yourself how you want to control the speed.
Further
programming possibilities
like DMX addressing are specified on the following
pages.
Tip:
When the motoryoke is in
programming mode
, all moving orders are ignored. Make sure
that the device is in operating mode after programming, otherwise it will not move! Press
two times the OK key for leaving the programming mode!
14
Motoryoke YipMan1 V4.58 Rev 1.00
