61
W
iring
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
WIRING
Connecting Optional LG Hydro Kit Accessories
5. Turn power off at the circuit breaker.
6. Open the Hydro Kit front panel / control box cover.
7. Route the Room Temperature Sensor cable through an opening in the bottom of the Hydro Kit.
Do not use the same access hole as
the power input cable.
Do not cut the sensor cable. If the cable is longer than necessary, coil and secure excess cable.
8. Insert the connector of the remote temperature button sensor cable into the CN-ROOM connector on the PCB.
9. Use a cable tie or other method to secure the remote temperature button sensor cable inside the Hydro Kit.
Do not allow strain on the
cable.
10. Reinstall the Hydro Kit front panel / control box cover, and apply power.
11. See the Controller and Pre-Commission sections for instructions on how to properly set the function code. For more information on the
remote temperature sensor, see the submittal and the installation manual on www.lghvac.com.