IP LDK-20 Programming Manual ADMIN Programming
248
Section 4. ADMIN programming
Ø
How to enter programming mode
1. Lift handset or press the
[MON]
button on the ADMIN station, and hear ICM dial tone
(optional)
2. Press the
[TRANS/PGM]
button and dial
•
#
(Confirmation tone is heard)
•
Enter ADMIN password if the password has been set. This places the station into
the ADMIN programming mode (Confirmation tone is heard)
3. Each program is accessed by pressing the
[TRANS/PGM]
button and dialing the
three-digit program number. If an error is made while entering data, the
[TRANS/PGM]
button can go the previous status. When the
[TRANS/PGM]
button is
pressed, the LCD will display;
* NOTE :
1. The step 2, “[TRANS/PGM]
è
•
è
# ”,
is omitted from the procedure in
ADMIN Programming.
2. To return the parent state while ADMIN programming, press the [CONF]
button. Pressing the [CONF] button, temporary data fields are cleared.
Ø
System Range(refer to this table in ADMIN Programming)
Station Range
CO Range
CO Line Group Range
Remark
10 ~ 35
01-12
01-08
This table is frequently used in ADMIN Programming procedure. As you can see from
the table, there are 3 items “ Station range, CO range, CO Line group Range”.
When entering each range, refer to the table because the range is not mentioned.
ENTER PGM NUMBER
Содержание IP LDK-20
