Lexmark 2580+, Руководство по обслуживанию

Страница: 46 / 122

3-10
Service Manual
2580+, 2581+, 2590+, 2591+
Go Back
Previous
Next
Printer settings
Setting the tear off position
When Auto Tear Off is on, or set to One Second, it moves the top perforation of a continuous form to the tear off
position, when all of the following are true:
•
The printer has finished printing.
•
The paper has advanced to the Top-of-form on the next page.
•
No data, printer control codes, or escape codes have been sent to the printer after advancing to the
Top-of-form.
•
The print buffer has not received data for one second.
If you have already set Top-of-Form and now want to change the tear off bar position, follow these steps:
1.
Press Start/Stop to take the printer offline.
2.
Press and hold Tear Off until the printer beeps.
3.
Open the operator panel cover to access layer two.
4.
Press Micro
↑
or Micro
↓
to move the paper to the correct position on the tear off bar.
5.
Close the operator panel cover. The printer beeps twice. The paper rolls backward, then goes to the new
tear off position. The Ready light is on.
The paper remains at the current tear off position until you send another job to the printer. The paper moves
from the tear off position to the Top-of-form and begins printing.
Setting Top-of-form (continuous-pull mode)
1.
Turn the printer on. The Paper Out light blinks if no paper is loaded.
2.
Move the Paper Select lever down to the continuous forms position.
3.
Load continuous form paper on the pull tractor feed pins.
4.
Open the operator panel cover to access layer two.
5.
Press any paper movement button ( LineFeed , Micro
↑ ,
or Micro
↓
) to move the paper to the Top-of-form
position.
6.
Use the second sheet of continuous forms to set Top-of-form.
7.
Press Set TOF to set and save Top-of-form.
8.
Close the operator panel cover. Top-of-form is not saved if the printer is turned off, or if it runs out of paper
when the printer is in Pull Tractor mode.
9.
Press Start/Stop to set the printer online.
Setting Top-of-form (cut forms, envelopes)
Top-of-form can range from minus 1 to plus 22 inches from the top of cut sheet paper. To set and save Top-of-
form:
1.
Turn the printer on. The Paper Out light blinks if no paper is loaded. If the Paper Out light is off, tear off
excess forms and press
Load/Unload . If an individual form is loaded, press FormFeed to clear the paper
path.
2.
Move the paper select lever up to the cut forms position.
3.
Load a cut sheet of paper or envelope through the manual feed door. The printer moves the paper or
envelope to the current Top-of-form if Auto Cut Sheet is set to on. If not, press
FormFeed when the Paper
Out light goes off.
4.
Open the operator panel cover to access layer two.
5.
Press any paper movement button ( LineFeed , Micro
↑ ,
or Micro
↓
) to align the horizontal lines (located
on the platen) with the Top-of-form you want.
6.
Press Set TOF to set and save Top-of-form.