Lauda Integral XT 150, Руководство по эксплуатации

Страница: 103 / 168

Integral XT
YAWE0028 / 24/06/2016
Starting up
101
7.15.6 Self Adaption
The function Self Adaption can be used to detect automatically the optimal control parameters for
internal or external control.
The Self Adaption can only be performed on a device with active cooling.
This function is available from software version 2.18 of Command. For thermostats with an older
software version a software update is necessary.
The Self Adaption determines the parameters by a test run of the thermostat. In this case the thermo-
stat and, if applicable, the external application must be ready for operation. (
þ
6).
The Self Adaption will be performed with the actually set pump step. Best results can be achieved
with high pump steps.
The test run must be performed at a passive system; this means that during the test run an exo- or
endotherrmic reaction mustn’t take place.
The test run takes depending on the external application about 30 minutes to 3 hours. The bath tem-
perature will oscillate in this time less than about ±15 Kelvin around the set temperature. After the test
run the detected control parameters will be taken over as control parameters automatically.
Command Self Adaption
−
Open the device parameter menu via
the soft key Menu .
−
With the cursor keys continue to:
à
Control
à
Control Parameters
à
Self Adaption
à
Settings .
−
Confirm selection with .
−
The window shown adjacent appears.
−
With the menu Status the test run of
the Self Adaption can be started.
When the Self Adaption is finished, the
test run will be terminated automatical-
ly.
−
As soon as start is pressed, in the
sofkey area the information Adaption
on will be displayed followed by the
actual status of the test run.
Pump Menu End T
set
T
fix
Control Parameters
Control para. sets
Tv manual/auto
Self Adaption
Correction limitation
Settings
Pump Menu End T
set
T
fix
Status
Setpoint
Identification
Actual Parameters
Start