Lantech LGS-2816C-RPS, Руководство пользователя

Страница: 19 / 248

B
ASIC
C
ONFIGURATION
S
ETTING
P
ASSWORDS
If this is your first time to log into the console interface, you could define
a new password for access to the web interface, record it, and put it in a
safe place. The password can consist of up to 15 alphanumeric
characters and is case sensitive. To prevent unauthorized access to the
switch, set the password as follows:
First to access the Switch via Console port and Type ― admin‖ default
username and ― admin‖ default password.
Then enter account configuration interface. Type ―modify admin,‖ where
password is your new password.
Managed Switch -
LGS-2816C-RPS
Login: admin
Password: *****
LGS-2816C-RPS(account)# modify admin
username/password: the length is from 5 to 15.
Current username (admin):admin
Current password:
New password:
Confirm password:
Username changed successfully.
Password changed successfully.
▼
Manual — You have to input the information, including IP address
and subnet mask. If your management station is not in the same IP
subnet as the switch, you will also need to specify the default gateway
router.
▼
Dynamic — The switch can obtain a IPv4 address from DHCP
address allocation servers on the network.
SETTING AN IP
ADDRESS
You must establish IP address information for the switch to obtain
management access through the network. This can be done in either
of the following ways:
M
ANUAL
C
ONFIGURATION
You can manually assign an IP address to the switch. You may also
need to specify a default gateway that resides between this device
and management stations that exist on another network segment.
Valid IPv4 addresses consist of four decimal numbers, 0 to 255,
separated by periods. Anything outside this format will not be
accepted by the CLI program.