1-8
F-581-R1
INTRODUCTION, SAFETY AND INSPECTION
Operators Daily Checklist
Status
Landoll / Bendi IC
SAFETY & OPERATIONAL CHECKS
Have a qualified technician correct all problems.
OK - Yes,No
Maintenance Note if Applicable
If Fuel Odor is detected - DO NOT START TRUCK -
REPORT IMMEDIATELY!
Forks, Top Clip Retaining Pin and Heel - Condition.
Load Backrest Extension - Attached.
Lift and Lowering Control - Functioning smoothly.
Tilt Control - Forward/Reverse Functioning smoothly.
Side Shift Control Functioning smoothly.
Hang-on Attachment functioning smoothly, securely
attached, fittings attached.
Steering Operation functioning smoothly.
Drive & Stop Pedal functioning smoothly.
Controls (Turn Power On) Investigate Unusual noises.
Dash Display (Hour Meter, Oil Temp, Voltmeter, etc
Functioning properly.)
Horn, Lights, Seat Switch functioning properly.
Service and Parking Brake functioning properly.
Drive Control- Forward/Reverse functioning smooth.
Engine Air Cleaner - Squeeze rubber dirt trap; Clean
and check.
Engine Belt - Check for wear.
Battery. (Check for cracks and electrolyte level.)
Hood and seat latch functioning properly.
Operator’s Compartment Capacity Plate Attached Info
matches Model, Serial No. and attachments -
Operator’s Manual in protective case.
Seat Belt, Buckle, and Retractors functioning properly.
Overhead Guard properly mounted & attached.
Radiator - Check Level in Overflow Tank.
LPG Hoses - Check for damage, kinks, correct fittings.
LPG Tank - Securely attached; free of rust, corrosion.
Look for damage of any kind.
Engine Oil, Hydraulic Oil, Brake Fluid - Check levels.
Water Pump - Inspect
Tires-Check for debris, Torque lug nuts -
225ft-lb(300Nm).
Finger Guards attached.
Major Structural Points (Front Rotation, Mast Braces,
Overhead Guard) - Check for cracks.
Hydraulic Cylinders, Pump, Valve-Check for leaks,
noise.
Safety Warnings Attached (See Manual for location).
Date
Inspector:
Truck No.
Model No.
Location
Serial No.
Shift
Hr Meter
Battery Fluid
Hydraulic Oil
Содержание Bendi B40i4
