Landoll Bendi B40i4, Руководство по обслуживанию

Страница: 105 / 142

CALIBRATION AND PROGRAMMING
4-5
10. 0,3-CP_Steer_RPM_Percent – Displays the
mapped steer angle as a percent of RPM.
11. 0,3-CP_LoadRamp - unused.
12. 0,3-CP_Propel_Command – Displays commanded
propel based on propel input from steer and pedal
vs. mapped propel modified by PID loop.
13. 0,3-CP_Pedal_mV – Pot wiper voltage.
14. 0,3-CP_Pedal_Pot - unused.
15. 0,3-CP_Propel_In – Displays the mapped Accel
pedal input.
16. 0,3-CP_LoadPropel – Shows the propel modified by
the PID loop.
17. 0,3-CP_RPM_CMD – Displays the RPM command
based on propel, lift, shift, and tilt commands.
18. 0,3-CP_Eng_RPM – Displays actual Engine RPM
“Transmitted from the GFI ECM”.
19. 0,3-CP_Seat_SW – On when operator is present,
Off when operator is not present.
20. 0,3-CP_Accel_Safety_SW – Displays the state of
the accel pedal “On when pedal is depressed, Off
when pedal is in the neutral position
21. 0,3-CP_HYD_OIL_TEMP – Displays the Hydraulic
oil temp “Thermistor-type sensor in hydraulic tank”.
22. 0,3-CP_HydFanCmd – Displays Fan command
based on min/max temperature scaled from 0 to
100%.
23. 0,3-CP_FanCmd – Displays the current supplied to
the coil on the fan valve.
24. 0,3-CP_1939EngTemp – Displays the Actual engine
temperature “Transmitted from the GFI ECM”.
25. 0,3-CP_EngFanCmd - Displays Fan command
based on min/max temperature scaled from 0 to
100%.
26. 0,3-CP_FORWARD_SW – Displays the state of the
direction Switch, On when forward is selected, Off
when forward is not selected.
27. 0,3-CP_REVERSE_SW - Displays the state of the
direction Switch, On when reverse is selected, Off
when reverse is not selected.
28. 0,3-CP_RPM_Percent – Displays the result of
Propel in added to load ramp, multiplied by 100 and
divided by the actual RPM commanded.
29. 0,3-CP_RPM_Pump_Percent – Displays the RPM
percent after it is mapped “Profile & time ramp”.
30. 0,3-CP_Final_Pump_Cmd – Displays the final pump
command based on actual command vs. limited
command based in temperature of hydraulic oil.
31. 0,3-CP_Fwd_EDC – Displays current supplied to coil
on the forward proportional valve.
32. 0,3-CP_Brk_CMD – Displays amount of Brake
command “driven by direction and amount
commanded is said direction.
33. 0,3-CP_Rev_EDC - Displays current supplied to coil
on the reverse proportional valve.
34. 0,3-CP_Lower_enable - Enables control of
secondary lowering valve that bypasses the lift lower
spool valve.
35. 0,3-CP_Lower_Valve - Shows the value being sent
to the secondary lowering valve for feedback.
36. 0,3-CP_LOWER_ON_OFF - Turns on secondary
lowering valve that bypasses the lift lower spool
valve.