Landoll Bendi B40i4, Руководство по обслуживанию

Страница: 28 / 142

2-2 F-581-R1
PLANNED MAINTENANCE
• When assembling two parts, start all of the fasteners
first, then tighten them evenly and in a staggered
manner. Be sure both mating surfaces are aligned,
not cocked or off-center.
• Observe standard torque ratings for the size and type
of fastener
as listed starting on page 1-17.
• Be sure to use the proper nuts, bolts and other
fasteners as rated; SAE Grade 5, SAE Grade 8, ISO
Prop Class 8.8, etc.
• All fasteners must be replaced with the identical type.
• It is recommended to use only Landoll authorized
replacement parts.

DANGER
Preparing for Inspection or
Maintenance
Before inspecting or maintaining the forklift all must
completely understand the general maintenance
instructions and cautions described on page 1-2:
• Inspect the forklift in an area that has sufficient
clearance to check all operator
functions.
• Lower forks to the ground and tilt mast forward.
• If you will not be operating the forklift to check
operator functions, block the wheels with chocks
and/or other positive forklift-positioning devices.
• If you will be operating the forklift to perform operator
functions, raise the drive wheels so they clear the
floor.
• Block the mast to prevent it from engaging.
• If you need to hoist the forklift make sure the hoisting
equipment has adequate size and capacity to move
the equipment.
• NEVER remove counterweights or uprights. This will
change the center of gravity and can cause an
unstable condition.
Performance Testing
NOTE
Make sure all accessories are off before continuing.
Make sure you are in the operator’s seat:
1. Make sure your right foot is on the floor of the
operator’s compartment and not on a pedal.
2. Set the direction lever in the neutral position. See
Figure 2-1.
3. Turn the key switch. Start engine and allow the switch
to return. See Figure 2-2.
4. Release parking brake. See Figure 2-3.
5. Set the direction lever in the forward position. See
Figure 2-1.
6. Check functions described in the Operator’s Daily
Checklist or other Checklists starting on page 1-7.
Figure 2-1: Direction Lever
Failure to follow these guidelines can cause
serious
injury or death:
• NEVER perform any maintenance or service
procedures unless specifically
indicated in
this manual or requested by your supervisor.
All other service and maintenance on your
Bendi B40i4 forklift must be provided by a
facility authorized by Landoll Corporation to
perform these services.
• Wipe up any spills immediately to prevent
slipping, fire, explosion, or contact with
hazardous materials.
• Failure to use lifting equipment of adequate
capacity to lift and move your Bendi B40i4
forklift can cause lifting equipment failure.
• Removing the counterweights or uprights will
change the center of gravity of the forklift and
can cause the forklift to tip. The engine is
considered part of the forklift’s
counterweight.
To help avoid fire hazards:
• Have fire extinguishing equipment present in
the work area.
• DO NOT allow sparks or open flames while
checking fluid level, leaking oil, or electrolyte.
• DO NOT use fuel or flammable cleaning fluids
to clean parts.