Adding a New VLAN:
Click to add a new VLAN ID. An empty row is added to the table, and the VLAN can be configured as needed. Legal
values for a VLAN ID are 1 through 4094.
The VLAN is enabled on the selected switch unit when you click on "Save". The VLAN is thereafter present on the other
switch units, but with no port members. The check box is greyed out when VLAN is displayed on other switches, but user
can add member ports to it.
A VLAN without any port members on any unit will be deleted when you click "Save".
The button can be used to undo the addition of new VLANs.
Buttons:
Save:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved values.
Refresh:
Refresh the VLAN entries manually.
Clear:
Clean up the VLAN table.
|<<, >>:
Go to the previous/next page of the table.
3.10.2 Ports
In the VLAN Tag Rule Settings, PVID number for each port can be set. The range of PVID numbers is from 1 to 4094.
Ingress filtering rules for each port are available. There are two ingress filtering rules which can be applied to the switch.
The Ingress Filtering Rule 1 is “forward only packets with PVID matching this port’s configured PVID”. The Ingress Filtering
Rule 2 is “drop untagged frame”. You can also select the Role of each port as Access, Trunk, or Hybrid.
Web Interface
To configure VLAN Port configuration in the web interface:
1. Click VLAN Port Configuration.
2. Specify the VLAN Port Configuration parameters.
3. Click Apply.
Figure 3-10.2: The VLAN Port Configuration (GS-2310P)
81
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
